Copying Pronto codes from one hardware iface to another
Posted: Mon Oct 12, 2009 9:05 pm
I'm building IR codes into/for the USB UIRT by copying the Pronto codes from the Ocelot hardware interface. After I copy/paste the Pronto code into the UIRT configuration screen and go back to the Ocelot IR config screen to get the next code (i.e. remote control function) the one I just copied is listed in the Ocelot IR config screen with an Ocelot module type. So each copy/paste process results in two listings on the Ocelot IR config screen. Looks like the "new" (USB UIRT) entry should not be listed on Ocelot IR config page. The created IR codes on the UIRT IR config page appear to be OK although I have not tested them. Make sense? I hope so because its sure hard to explain.