HouseBot

Forgive the newbie question.



When I first setup Housebot, I define a new hardware interface. In the "Type of Hardware" pull down menu, I expect to see a CM11A, but it is not listed. There is a Generic Serial Module, but it would then need to be customized. I have no files in the Housebot subdirectories beginning with CM11*.*. Should there be?



Also, I tried to define a hardware interface using the Generic Serial Device, but it idoes not show up in the interface pull down menu of the new device. In the hardware interface, I have "Enabled" set to yes.





This is a new installation of version 1.52 downloaded yesterday.



Thanks,

Bob

Darn Newbies !



Reinstalled, found the CM11A check box in the installation and now have the CM11A definition. Duh ! Thought I had selected that before, finger check I guess.

Rockstar,



Glad you figured it out.



Good luck,

Scott