I have a panel that It's 'Enter List" has a task that opens a second panel.
The first panel has buttons to open the second panel with context, and the second panel has a remote label to display the current context.
The problem is to display the current context label when first displaying the panels (without pressing any of the panel change).
Is there a way to display the default context label?
Default Context text
-
- HouseBot Guru Extraordinaire
- Posts: 1121
- Joined: Tue Sep 28, 2004 7:49 am
- Location: The Netherlands
Re: Default Context text
You might try the script command "OpenRemotePanelAndSetContext" to first open from the Enter List.
-
- HouseBot Special Member
- Posts: 304
- Joined: Wed May 07, 2003 2:19 pm
- Location: Tel-Aviv, Israel
- Contact:
Re: Default Context text
Thank you,
That's nice but this script command opens the panel on all software remotes, whereas I need it on the calling remote only.
That's nice but this script command opens the panel on all software remotes, whereas I need it on the calling remote only.
-
- HouseBot Guru Extraordinaire
- Posts: 1121
- Joined: Tue Sep 28, 2004 7:49 am
- Location: The Netherlands
Re: Default Context text
OK that might be true. I run only only remote and use a video matrix to get the same remote everywhere else in the house. When using a remote device I use VNC.
So never made a difference between calling or all remotes. Too bad
So never made a difference between calling or all remotes. Too bad