Hi, I have serial device under HW interface and I like that port is on when I run HB. Is this possible, becouse now that state is remembered from last state when you close HB.
BR
Sandi
Auto enable HW interface
-
Richard Naninck
- HouseBot Guru Extraordinaire
- Posts: 1121
- Joined: Tue Sep 28, 2004 7:49 am
- Location: The Netherlands
Re: Auto enable HW interface
Not sure what you are getting at but if the last state is remembered, than if you have the serial device enabled before closing, it will be enabled after starting HB again..
-
kolesar007
- Member
- Posts: 14
- Joined: Sun Dec 02, 2007 11:15 am
Re: Auto enable HW interface
I know that but I want to auto enable even if I close medio with disabled HW interface. Or if it is possible to control HW interface trough script.
-
Richard Naninck
- HouseBot Guru Extraordinaire
- Posts: 1121
- Joined: Tue Sep 28, 2004 7:49 am
- Location: The Netherlands
Re: Auto enable HW interface
Hardware interfaces cannot be enabled through scripts or tasks. Only through the HBServer GUI.
Why would you want to disable the interface?
Why would you want to disable the interface?